Panel schedules in Revit MEP 2012 are more powerful than before -
- you can tell the circuit table to use either load or current as the value in the table (amps vs. vA);
- you can can now tell the schedule to place as many rows as you have circuits assigned in the general circuit settings;
- you can freeze the size of the row or column so that the schedules are consistent sized when placed on a sheet;
- you can also go to electrical settings and change the general settings for capitalizing the load names.
But here's the part we don't always teach - how do I apply these changes to the panel schedules I already have?
Simple - on the manage tab, choose Panel Schedule Templates, and then pick Manage Templates. On this tab, pick the Apply Templates tab.
All you have to do is pick your template and then pick the schedules you want to apply it to.There's a couple of limits with this - you can only apply template to panels of the same type (i.e., you can't apply a switchboard template to a branch panel template), but you have to do this if you make any changes to a template - since the adjustments are not automatically applied.
So tweak the daylights out of your templates until you get them looking and running the way you want!
later - David B.
1 comment:
Thanks for publishing material about this. I´m implementing Revit MEP for electrical design in the company I work and it´s very hard to find information. Greeting from Chile
Post a Comment